无锡科达脚手架厂【官网】主营:脚手架、移动脚手架、门式脚手架、梯形脚手架

无锡科达脚手架厂

示例图片三
网站首页 > 新闻资讯 > 时事新闻

热风炉安装知识及产排污问题

2018-11-29 09:27:09 无锡科达脚手架厂 阅读

对于目前市场来说,燃气成都收账热风炉是一种非常好成都找人公司热风炉节能环保,并且效率高,但是要让热风炉更好成都收账使用,需要注意热风炉收账安装问题。因为,再好成都找人公司燃气热风炉如果在安装的时候不把热风炉安装到位,正确的安装好,那么在使用的时候想完美的使用也是不可能的。热风炉的安装:在安装热风炉前需要有一定的方案布置,确定成都找人公司房的位置,成都收账公司房的大小,还有成都收账公司房的高度等等,因为热风炉都是用来提供热能的,所以热风炉房的温度是非常好的,所以安装好的热风炉要留有充分的过道,保证通风还有行人的经过。并且最好选择在行人经过比较少的位置。

For the current market, gas-fired hot stove is a very good hot stove energy-saving and environmental protection, and high efficiency, but to make the hot stove better use, we need to pay attention to the installation of hot stoves. Because, no matter how good the gas hot-blast stove is, if it is not installed in place and installed correctly, it is impossible to use it perfectly when using it. Installation of hot stove: 

Before installing the hot blast stove, we need to have a certain plan layout, determine the location of the hot blast stove room, the size of the hot blast stove room, and the height of the hot blast stove room, etc. Because the hot blast stove is used to provide heat energy, so the temperature of the hot blast stove room is very good, so the installed hot blast stove should have sufficient passageway to ensure the passage through. The wind and the passing of pedestrians. And it's better to choose a place where pedestrians pass less.

在接下来的安装步奏中还要注意到的问题就是通风,因为燃气热风炉在使用的过程中会产生大量的油烟,即使每个燃气热风炉都有专门的排烟设施,但是在安装的时候依旧要注意通风的问题。注意通风有两个好处,第一就是有利于烟雾的排放,第二就是能够保持热风炉房内的温度,使温度置之于过高,使人在其中感觉不舒服。

In the next step of installation, we should also pay attention to the problem of ventilation, because the use of gas hot stoves will produce a large number of fumes, even if each gas hot stove has a special smoke exhaust facilities, but still pay attention to the problem of ventilation during installation. Note that ventilation has two advantages: first, it is conducive to smoke emissions; second, it can keep the temperature in the hot stove room, so that the temperature is too high, making people feel uncomfortable in it.

热风炉的排污:

Discharge of hot stove:

当燃气热风炉使用一段时间之后,我们需要定期的去进行排污工作,在排污期间,有哪些步骤呢,我们需要注意哪些呢,下面来看下:

When the gas hot blast stove is used for a period of time, we need to regularly carry out the work of sewage discharge. During the period of sewage discharge, what steps do we need to pay attention to?

1、开启定期排污总阀;

1. Open the regular sewage discharge main valve;

2、先开一次阀,再缓慢开启二次阀;

2. Open the second valve slowly after opening the first valve.

3、排污完毕后,先关二次阀,后关一次阀;排污应缓慢进行,防止水冲击,如管道发生严重振动,应停止排污,待故障消除后再进行排污;

3. After the sewage is discharged, the secondary valve should be shut down first, and then the primary valve should be shut down. The sewage should be discharged slowly to prevent water impact. If the pipeline has serious vibration, the sewage should be stopped and the sewage should be discharged after the fault is eliminated.

4、在排污过程中,如热风炉发生事故,应立即停止排污,但汽包水位过高和汽水共腾除外;

4. In the process of sewage discharge, if an accident occurs in the hot blast stove, the sewage discharge shall be stopped immediately, except for the excessive water level of the drum and the co-evaporation of steam and water.

5、禁止两台热风炉同时进行排污。

5. It is forbidden to discharge pollutants simultaneously from two hot stoves.

燃气热风炉软化水设备原水由进水口进入控制阀,从阀芯的上部经阀体,并由顶部进入罐内。然后,向下穿过树脂层,成为软化水,经下布水器返回中心管,向上至阀体,经阀芯后从软化水设备出水口排出。软化水设备原水由进水口进入控制阀,经阀芯进入射嘴的进口,并快速流向射嘴出口,产生负压,从而将盐罐内的盐水从吸盐口吸入阀体,进入罐体的顶部。这样整个的燃气热风炉排污步骤就结束了,我们在后期处理时,也要注意排污期间出现的问题,及时的去进行解决,做好整体的使用。

The raw water of softening water equipment of gas hot blast stove enters the control valve from the inlet, passes through the valve body from the upper part of the valve core, and enters the tank from the top. Then, it passes down through the resin layer to become softening water, returns to the central pipe through the lower water distributor, goes up to the valve body, and discharges from the outlet of the softening water equipment through the valve core. The raw water of the softening water equipment enters the control valve from the intake port, enters the nozzle through the valve core, and flows rapidly to the nozzle outlet to generate negative pressure, thus brine in the salt tank is sucked into the valve body from the salt suction port and enters the top of the tank body. In this way, the whole process of gas hot blast stove drainage is over. We should also pay attention to the problems during the drainage period, solve them in time, and make good use of the whole.



标签:   热风炉 热风炉厂家 脚手架 移动脚手架 脚手架厂家 梯形脚手架 门式脚手架