The inspection criteria of scaffolding engineering are mainly shown in the following aspects: 1. The quality of materials used in mobile scaffolding must meet the requirements. 2, scaffold foundation is solid, no water, there is a request for the backing plate. 3. The horizontal error of the full length of the large cross bar shall not exceed 6 cm. The vertical error of the vertical bar shall not exceed 1/200 of the elevation, the deflection of the small cross bar shall not exceed 1/150 of the length of the bar, and the spacing of the bar shall meet the planning requirements. 4. To satisfy the need for a wall point, a vertical interval of every 4 m, a horizontal interval of 6 m, and the building is firmly tied.
5. The work floor should be strictly laid, flat and stable, and the corners should be circled (that is, the footboards should be laid in place with the footboards laid horizontally). The length of the plank is wide and narrow, and there is no probe plate. The raw material meets the request. 6、工作面防护，立挂安全网加挡脚板或绑两道护身栏杆，加18cm挡脚板，工作面端头封死。
6. Work face protection, hang safety net with foot guard or tie two guard railings, add 18cm foot guard, the end of the face is sealed.
7. Safety nets should have factory certificates and inspection certificates. Flat nets should be set up with high outside and low inside, close overlap between two and even stress. The vertical net is tied up with the big cross bar, and the bottom of the vertical net should be pressed under the feet and hands of the working face. (mostly not)
8. After the external scaffolding is erected, it is necessary for the relevant personnel to check the inspection signatures and confirm that they are qualified before they can be put into use. Achieve layered construction, stratified inspection, stratified use, found problems timely reinforcement. No scaffold can be arbitrarily dismantled and altered without the consent of the external scaffold.
标签:   脚手架 移动脚手架 脚手架厂家 门式脚手架 梯形脚手架